Program a Plug And Play Shade to the Handheld Remote
Pair the handheld remote with your Plug and Play Quiltcraft roller or roman shade with these instructions. Keep in mind that the steps to program your controls vary depending on the type of motor on your roller shade. Check out the details below!
Note: When working with multiple motorized shades, power only the one being programmed.
You will need a paper clip on hand!
Steps:
Remove plug from power for 2 seconds. Plug in shade power cord for 10 seconds. Remove plug from power for 2 seconds. Plug in cord again and leave in place. Roller shade will jog* once. Insert paper clip in Programming Port on remote. Press and hold for aproximately 20 seconds until roller shade jogs twice.
On the remote, select a channel to link by pressing the Channel button. The LED Indicator will illuminate the channel selected.
Press and hold UP and DOWN buttons simultaneously until shade jogs once. Switch is now paired to the motor.
Test roller shade by pressing DOWN.
If direction is incorrect, press and hold MY button until shade jogs once to modify direction. Repeat step 4 to confirm.
Press UP to move the shade to the desired upper position. Press and hold MY and DOWN simultaneously until shade starts to move, then release. Upper limit is now programmed.
If shade stops when buttons are released, take back to upper limit and repeat. Stop shade at desired location by pressing MY.
Press and hold MY and UP simultaneously until shade starts to move, then release. Lower limit is now programmed.
To confirm and complete limit programming, press and hold the MY button until shade jogs once.
Find the red Programming button located in the back of the remote, insert paper clip briefly and press (no need to hold down). Shade will jog once to indicate it is in user mode (no longer in programming mode).
Repeat steps 1-8 for subsequent channels/motors.
*A Jog is a brief up and down motion.
Explore Similar Resources
